Hair Unit Care Guide
Maintain Your
Unit Like a Pro
A step-by-step maintenance process for long-lasting wear, a healthy scalp and a flawless finish every time.
01
Before You Begin
What You'll Need
🧴
C22 Solvent Remover
Breaks down stubborn adhesive from the base and scalp
💧
Rubbing Alcohol
Degreases the scalp before bonding
🛡️
Scalp Protector
Protects skin from direct adhesive contact
🔗
Ghost Bond Adhesive
Primary bonding agent — 2 to 3 layers required
📐
Pencil + 3-Way Mirror
For accurate hairline positioning
01
Step One
Remove the Unit
→
Carefully lift the unit from your headPeel slowly — never pull hard at the front hairline
→
Roll adhesive off the base using a towel, cotton wool or your fingersWork from the edges inward in small circular motions
→
Use C22 solvent if adhesive is stubbornApply to the base, let it sit briefly, then roll off
02
Step Two
Clean Your Scalp
Remove Residue
- Roll remaining adhesive from scalp using cotton wool or towel
- Use C22 or rubbing alcohol to clear stubborn residue
- Be gentle around the hairline edges
Scalp Health
- Shave the horseshoe area with a trimmer
- Shampoo and condition your remaining hair as usual
- Let your scalp breathe for a few hours where possible
✓ Scalp breathing time reduces irritation and improves next bond
03
Step Three — If Needed
Wash the Unit
⚠ Only wash when product build-up or odour is present
1
Use warm water to gently wash and rinseAlways support the base — never scrub aggressively
2
Shampoo and condition at least twiceRemoves product build-up and any unpleasant odours
3
Dry on cool air or leave to dry naturallyNever use hot air — it damages the base and hair fibres
04
Step Four
Mark Your Hairline
🪞
Use a 3-Way Mirror
Check all angles — front, left and right — before marking
✏️
Pencil the Line
Place the dry unit, position carefully, then mark the hairline on your forehead
📏
Remove and Set Aside
Lift the unit off and keep it safe — this line is your bonding guide
05
Step Five
Prep for Bonding
1
Wipe the shaved scalp with rubbing alcoholUse a towel or cotton wool — removes all oils from the skin
2
Apply your scalp protector of choiceStay within your pencil line guide — allow to dry fully before continuing
3
Apply 2 to 3 layers of Ghost Bond adhesiveEach layer must dry clear before applying the next — never rush this step
⚠ Applying over wet adhesive is the most common bonding mistake
06
Step Six
Apply the Unit
👆
Front to Back
Always place the hairline first, then lay back to rear. Use your pencil mark as the anchor point.
💨
Positioning Spray
Use a positioning spray if you need extra time to manoeuvre the unit before it sets.
🤲
Press Firmly
Work across the entire base — apply even pressure to activate the bond from edge to edge.
⏱️
Give it Time
Allow the adhesive to fully cure before sweating, washing or heavy styling.
07
Final Step
Condition, Comb
& Style
Apply a leave-in conditioner or light styling product, comb through gently from root to tip and finish with your preferred style. Done.
✓ Avoid heavy product near the hairline — it shortens bond life
Carter Creative Hair Studio
Any Questions?
Your next appointment is where we refine the process together. See you in the studio.
📍 Pollard Yard, Manchester
🌐 cartercreative.uk
CC
Stay Connected
Follow & Shop
Recommended Products